A very versatile item, the RAM Universal Finger Grip Holder is especially good for securing larger phones and electronics, as well as hand-held radios. Includes three sets of four flexible, rubber-coated fingers to accommodate devices of different depths. Removable top and bottoms supports on the backplate offer extra security, and you can position and adjust the fingers so that all buttons, controls, and jacks remain accessible. Includes the stainless steel machine screws and self-locking nuts you will need to attach it to a RAM base (not included),
which will provide the 1-inch ball you'll need to connect your holder to a RAM arm socket. Note that one of the features of this holder is the ability to vary the position of the base on the backplate to suit the tight confines of your cockpit.
The installation of this holder requires B238U Diamond Base or a B202 Round Base, as well as a RAM mount and RAM arm.
If you want to save a few bucks, check out one of the RAM Mounting Kits, which typically include a base, an arm, and a mount for less than the cost of buying each component separately.
Backplate measures 2 x 5 inches
Height dimensions using the removable top and bottom supports: minimum 5.25 inches, maximum 6 inches
Width dimensions using short finger clamps: minimum 1.25 inches, maximum 3 inches; depth 0.75 inches
Width dimensions using medium finger clamps: minimum 1.5 inches, maximum 3.5 inches; depth 1.25 inches
Width dimensions using long finger clamps: minimum 2.25 inches, maximum 3.5 inches; depth 1.6 inches